Welcome guest, please Login or Register

You are here: HomeForum Home → The Watering Hole → Generally Speaking → Thread


Installation needs attention


Total Posts: 20

Joined 2018-01-22

Installation needs attention
IMPORTANT: Maintain the 1?4 inch space around cabinets,pvc balcony railings philippine supplier
pipes, toilet flanges and any obstacle in the floor
For plank installation, staggering the end joints a minimum of 6 inches is required.
For tile installation, staggering the end joints a minimum of 3 inches is required. 
Note: Do not install four corners together, as this will not provide a stable installation. Plastic Wood decking Denmark
Clicking Planks/Tiles Together: To click the end joint of the plank/tile together, click the short side of the plank/tile vertically into the previous one by pressing it by hand and rolling it with a hand roller or seam roller to ensure a fully compressed tight fit.  To click the length joint of the plank/tile together, you can place long joint together, lifting slightly to engage lock. Rotate downward, clicking together for a tight fit. Use a small hand roller or seam roller to press/lock the compression fit end joint. If there are any gaps, we recommend using a small scrap piece of plank/tile with the lock on the edge. Lock groove-to-tongue or tongue-to-groove for this application. Lock the scrap piece to the area requiring tapping, and lightly tap the edge of the material.pvc picket fence dubaihis will bring
the tile edges tight together. Cut the plank/tile by scoring through the top wear layer with a utility knife then snap the plank/ tile across the score. Install adjoining rows as you did the first; one piece at a time. Holding the plank/tile at a slight angle, place it against the profile in the first row. Rotate the plank/tile down to secure the length joint assuring there are no gaps along the joint. The adjoining planks/tiles are aligned by sliding the long joint into position, shifting it to properly match the end joint against the previous plank/tile. Repeat until you reach the final row of material. To install the final row of planks/tiles, you will usually need to cut them. We recommend the following: lay a panel on top of the last row installed. wood flooring wpc decking from sri lanka
Lay another plank/tile against the edge of the wall. Mark the plank/tile underneath. Cut the plank/tile through the wear layer and snap along the score. Install the last row leaving ample expansion space. Once installation is complete we recommend rolling the floor with a 100lb roller to insure the flooring is locked in well.